Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Surface Roughness of the Surface Milled with Ball Nose End Mills (CROSBI ID 470352)

Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija

Udiljak, Toma ; Motika, Romano Surface Roughness of the Surface Milled with Ball Nose End Mills // Proceedings of the 9th International Symposium of DAAAM / Katalinić, Branko (ur.). Beč: DAAAM International Vienna, 1998. str. 471-472-x

Podaci o odgovornosti

Udiljak, Toma ; Motika, Romano

engleski

Surface Roughness of the Surface Milled with Ball Nose End Mills

It seeems that high speed machining (HSM) is a key driving force for the development in the domain of cutting theory and machine tool design and control in this decade. The increase of cutting speed and feed rate by factor of 5-10 allows reduction of machine time and increase of surface quality. This paper presents the results of invetigation of infulence of the cutting data and position of cuuting tool axes in regards to the feed rate direction on the surface roughness. The obtained results proves that better surface roughness should be expected when angle between cutting tool axes and machined surface is different then 90, what is of high importance when comparing 3-axes and 5-axes machine tools, same as when preparing cutting tool path.

high speed cutting; surface roughness; modeling

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o prilogu

471-472-x.

1998.

nije evidentirano

objavljeno

Podaci o matičnoj publikaciji

Proceedings of the 9th International Symposium of DAAAM

Katalinić, Branko

Beč: DAAAM International Vienna

Podaci o skupu

9th International DAAAM Symposium

predavanje

22.09.1998-24.09.1998

Cluj-Napoca, Rumunjska

Povezanost rada

Strojarstvo