Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Bending in two stages (CROSBI ID 100177)

Prilog u časopisu | izvorni znanstveni rad

Grizelj, Branko Bending in two stages // Journal for technology of plasticity, 28 (2003), 1-2; 99-106-x

Podaci o odgovornosti

Grizelj, Branko

engleski

Bending in two stages

In manufacturing of-working parts by metal forming there are a number of various methods, owing to sorts and largeness of parts as well as the demands for form and accuracy that cause different procedures and ways of bending process. Elastic part of deformation causes aberration of form and accuracy in bending. The important criterion in validation of bended parts presents the aberration of bending angle. As a measure for angle accuracy, it can be taken into account a relative error of bending angle. For the improvement of accuracy it is used a model, that compensate the mechanical spring back. The influence of mechanical spring back on bending angle can be eliminated, if it is in certain range of opposite direction and the same amount. The following elements extent influence on bending: press-brak, die, work piece geometry, product properties and friction. In this paper are analysed the influences onto the precision bending in two stages.

bending; tool; part geometry; bending in two stages

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

28 (1-2)

2003.

99-106-x

objavljeno

0354-3870

Povezanost rada

Strojarstvo