Transfer Impedance Measurement of UTP or STP Cable for 100 Mbit/s Data Transmission Rate (CROSBI ID 466124)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Nađ, Robert ; Koren, Zlatko ; Modlic, Borivoj
engleski
Transfer Impedance Measurement of UTP or STP Cable for 100 Mbit/s Data Transmission Rate
Measurement of electrical performance of multi-wire shielded structure twisted pair (STP) and unshielded twisted pair (UTP) cables is more difficult than measurement of simple coaxial cable. Characteristic impedance of twisted - pair cable which is usually symmetrical, has values higher than 50 ohm, therefore impedance transformers were necessary. For accurate measurements using impedance matching transformers, deembeding technique is recommended. The transfer impedance of multi-wire shielded twisted pair (STP) cable was measured using IEC 96-1 triaxial method by a modified test-setup.
measurement; characteristic impedance; STP; UTP; impedance transformer; deembeding; triaxial method
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
45-48-x.
1996.
objavljeno
Podaci o matičnoj publikaciji
Dobrowiecki, T., Zoltan, I.
Budimpešta: International Measurement Confederation (IMEKO)
Podaci o skupu
8th IMEKO TC-4 Symposium on New Measurement and Calibration Methods of Electrical Quantities and Instruments
predavanje
16.09.1996-17.09.1996
Budimpešta, Mađarska