Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

In-depth analysis of the mathematical model of polyester thermosets curing (CROSBI ID 108165)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Kosar, Vanja ; Gomzi, Zoran In-depth analysis of the mathematical model of polyester thermosets curing // European polymer journal, 40 (2004), 12; 2793-2802. doi: 10.1016/j.eurpolymj.2004.07.027

Podaci o odgovornosti

Kosar, Vanja ; Gomzi, Zoran

engleski

In-depth analysis of the mathematical model of polyester thermosets curing

In many areas of chemical engineering applications we have to deal with thermosetting polymer structures. One of the major processing techniques for producing such structures is the curing process. This process may be accompanied by undesirable thermal spiking phenomena during which the released energy may be trapped inside the structure. In order to predict the onset of this phenomenon models that couple reaction kinetics and heat transfer are required. The numerical model was constructed by taking into account the heat transferred by conduction through the resin, as well as the kinetics of heat generated by the cure reaction. The contributions to the rise in temperature from heat conduction and chemical reactions are different in different parts of the composite, which can be explained by the temperature-time, or conversion-time histories. The temperatures were measured in the center of a cylindrically shaped mold. Initiator concentration varied from 0.5% to 2.0% of mass fraction throughout the experiments, which governed the reaction kinetics. Introduction of the carbon base filler reduced the amount of heat generated in the composite, and as a result lowered the temperatures of the resin. The analysis of parameter sensitivity and model simulation was performed with data obtained. A good agreement was observed between experimental data and the mathematical model of the curing process in the mold.

thermoset ; spiking phenomena ; parameter sensitivity ; curing ; polyester resin ; inert filler ; mold ; kinetic model

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

40 (12)

2004.

2793-2802

objavljeno

0014-3057

1873-1945

10.1016/j.eurpolymj.2004.07.027

Povezanost rada

Kemijsko inženjerstvo

Poveznice
Indeksiranost