Development of a Product for Injection Moulding (CROSBI ID 510954)
Prilog sa skupa u zborniku | sažetak izlaganja sa skupa | međunarodna recenzija
Podaci o odgovornosti
Bujanić, Božo ; Šercer, Mladen ; Godec, Damir
engleski
Development of a Product for Injection Moulding
The development of a new polymeric product starts with the phase of research and development planning. The phase of technological design follows. In this phase it is necessary for the designers to realize that the product design quality directly depends on characteristics of production process and characteristics of plastics. Large number of different types of plastic materials makes development process very complex. In this work, CAE tools will be used for the new plastic product development. During development process special attention will be put on the choice of the material. Also, simulation of injection moulding will be conducted in order to avoid potential moulding problems. Results gained from the simulation will be used for the optimization of an existing product design, for the mould development and for optimization of processing parameters, e.g. injection pressure, mould cavity temperature, etc.
product development; CAE tools; computer simulation
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
2005.
objavljeno
Podaci o matičnoj publikaciji
21st Annual Meeting of the Polymer Processing Society PPS-21
Radusch, Hans-Joachim
Halle: Martin Luther University Halle-Wittenberg
Podaci o skupu
PPS-21
predavanje
19.06.2005-23.06.2005
Leipzig, Njemačka