Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Experimental testing of masonry and masonry piers (CROSBI ID 543309)

Prilog sa skupa u časopisu | stručni rad | međunarodna recenzija

Matošević, Đurđica ; Zovkić, Jurko ; Sigmund, Vladimir Experimental testing of masonry and masonry piers // Zbornik radova Građevinskog fakulteta Sveučilišta u Mostaru / Čolak, Ivo (ur.). 2008. str. 397-408

Podaci o odgovornosti

Matošević, Đurđica ; Zovkić, Jurko ; Sigmund, Vladimir

engleski

Experimental testing of masonry and masonry piers

In this work presented are the new testing methods and so determined mechanical properties of the masonry bricks and mortar produced and used in Croatia for regular masonry buildings. Testing methods and procedures are as specified in Eurocode 6: Design of masonry structures (1 and 2) and relevant European standards. According to EC6 and EC8, only the use of dimensioned masonry units is allowed for the construction of masonry buildings. Requirements regarding materials and manufacture, dimensions and tolerances, density mechanical strength, water absorption, frost resistance, soluble salt content, etc. are specified for each type of masonry unit. The experimental methods and results of the preformed tests are presented for three different brick elements commonly used in Croatia: perforated fired clay block, perforated concrete block and aerated-autoclaved concrete blocks. Mortar used for binding the blocks together was general purpose mixed cement-lime mortar M5. For verification of the load bearing capacity of masonry walls and structures for vertical and lateral loads, the values of mechanical properties of masonry considered as an assemblage of masonry units and mortar, and not mechanical properties of constituent materials are used. Tests outlined and performed are the typical ones for determination of the brick group, compressive strength of a brick, shear strength of the wall segments, compressive strength of wall segments and modulus of elasticity of the wall segment. They represent the main input data for any further analysis of the masonry buildings and they could be used as good reference for designers, brick industry and masonry builders in Croatia.

masonry; experimental test setup; brick types; masonry wall characteristics

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o prilogu

397-408.

2008.

nije evidentirano

objavljeno

Podaci o matičnoj publikaciji

Zbornik radova Građevinskog fakulteta Sveučilišta u Mostaru

Čolak, Ivo

Mostar: Sveučilište u Mostaru ; DAAAM International Vienna

1512-9322

Podaci o skupu

Internationa Scientific Symposium Modeling of Structures

predavanje

13.11.2008-15.11.2008

Mostar, Bosna i Hercegovina

Povezanost rada

Građevinarstvo