engleski

The properties of Portland cement - limestone - silica fume mortars

This work has studied the influence of the combined action of silica fume and limestone on strength development, porosity, pore structure and morphological features in the system where 15 wt% of cement was substituted by finely ground limestone. Silica fume was added in amounts of 0, 2, 5, 8, 11 and 15 wt% on a cement basis, respectively. It has been established that limestone addition considerably increases the total porosity of mortars. However, if introduced together with silica fume up to 8 wt% of silica, porosity decreases. More than 8 wt% of silica increases the porosity again. The cement mortar containing 8 wt% of silica fume shows the highest compressive strength, the minimum value of the total porosity, and its pore size distribution curve shows a discontinuous pore structure. Limestone is taken up to the system and reacts with aluminate and ferrite phases from cement. Approximately 5 wt% is available for reaction after 120 days hydration of mortars containing no silica fume. The quantity of limestone incorporated is affected by the silica fume content. The replacement of Portland cement by 15 wt% of silica fume causes reduction both in the amount of cement and in the free CH content available for limestone chemical activity, and in this condition limestone acts only as a filler addition.

microstructure; silica fume; limestone; mortar

nije evidentirano