Cutting force analysis in face milling using rotatable central composite design of experiments and Taguchi method (CROSBI ID 567734)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Bajić, Dražen ; Jozić, Sonja ; Celent, Luka
engleski
Cutting force analysis in face milling using rotatable central composite design of experiments and Taguchi method
This paper presents a study of the influence of cutting conditions on the cutting force components during face milling of steel 42CrMo4. Two experimental plans, rotatable central composite design and the Taguchi method with orthogonal arrays and signal-to-noise ratio, have been designed and performed on controlled machining with corresponding cutting conditions. Equations for the cutting force components, as a functions of cutting parameters, have been obtained by means of regression analysis. The Taguchi method has been used to analyse impact of cutting parameters on the cutting force components and to find optimal level of the cutting parameters. The comparison of results obtained by means of the rotatable central composite design and the Taguchi method was performed.
face milling; cutting forces; design of experiments; regression analysis; Taguchy method.
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
52-59.
2010.
objavljeno
Podaci o matičnoj publikaciji
Mechanical technologies and structural materials 2010
dr.sc. Dražen Živković
Split: Hrvatsko društvo za strojarske tehnologije (HDST)
1847-7917
Podaci o skupu
1st INTERNATIONAL CONFERENCE MTSM 2010
predavanje
21.10.2010-22.10.2010
Split, Hrvatska