Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Influence of Dead-time on Design of LCL-filter for Three-phase Voltage Source Converter (CROSBI ID 600668)

Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija

Majić, Goran ; Despalatović, Marin ; Terzić Božo ; Slutej Alojz Influence of Dead-time on Design of LCL-filter for Three-phase Voltage Source Converter // EDPE 2013 Conference Proceedings / Kolonić, Fetah ; Matuško, Jadranko (ur.). Zagreb: Hrvatsko društvo za komunikacije, računarstvo, elektroniku, mjerenja I automatiku (KoREMA), 2013. str. 54-60

Podaci o odgovornosti

Majić, Goran ; Despalatović, Marin ; Terzić Božo ; Slutej Alojz

engleski

Influence of Dead-time on Design of LCL-filter for Three-phase Voltage Source Converter

Today, three-phase voltage source converters (VSC) are connected to the grid through LCL-filters. This is because the LCL-filters can achieve higher damping than L-filters for the same volume, i.e. price. For the purposes of the LCL-filter design and optimization procedures usually all nonlinearities of the converter are neglected. The dead-time is a safety measure used to prevent the simultaneous conduction of semiconductor switches in the same phase leg of a given converter. Essentially, it represents a nonlinearity introduced into the system. This paper focuses on the deadtime concept and its influence on three-phase VSC performance in steady-state. The influence of dead-time is analysed by comparing harmonic spectrums of the converter AC voltage and the current at the point of common coupling for various values of dead-time. The use of simulation model is a simple and straightforward way to carry out this analysis. The simulation results, obtained for the case of zero dead-time and double-edge naturally sampled pulse width modulation (PWM), are numerically validated by comparing harmonic spectrums with well-known analytical solutions for the selected PWM strategy. The results presented in this paper clearly show that the dead-time should not be omitted from the harmonic spectrum analysis, and from the filter design and optimization procedures. This indicates that similar analysis should be done for other nonlinearities present in the system.

Dead-time; harmonic analysis; LCL-filter design; pulse width modulation; voltage source converters; virtual voltage harmonic spectrum

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o prilogu

54-60.

2013.

objavljeno

Podaci o matičnoj publikaciji

EDPE 2013 Conference Proceedings

Kolonić, Fetah ; Matuško, Jadranko

Zagreb: Hrvatsko društvo za komunikacije, računarstvo, elektroniku, mjerenja I automatiku (KoREMA)

978-953-56937-8-9

1339-3944

Podaci o skupu

17th International Conference on Electrical Drives and Power Electronics – EDPE 2013

predavanje

02.10.2013-04.10.2013

Dubrovnik, Hrvatska

Povezanost rada

Elektrotehnika