Infiltrants and roughness of 3D printed models (CROSBI ID 601325)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Galeta, Tomislav ; Šimunović, Goran ; Ćurić, Ante
engleski
Infiltrants and roughness of 3D printed models
3D printing developers persistently introduces new base materials and various strengthening infiltrants. Professional users need detailed information about properties of 3D printed models and they often ask about surface roughness. Therefore in this paper we have tested roughness of 3D printed samples strengthened with usual but also with alternative infiltrants. In order to estimate possible enhancement, after initial roughness measurement raw samples were sanded and roughness were measured again The lowest average roughness was obtained for samples infiltrated by cyanoacrylate, followed by wax and Protektin. The highest average roughness was for water and for epoxy resin. Sanding of samples had lowered roughness significantly for water and epoxy resin, thereby leveling it to values of other infiltrants. For other infiltrants, sanding had not provided noteworthy improvement of roughness.
3D printing; roughness; strengthening infiltrants
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
2-5.
2013.
objavljeno
Podaci o matičnoj publikaciji
Proceedings of the 5th International Scientific and Expert Conference
Lehocká, Dominika ; Cárach, Ján ; Knapčíková, Lucia ; Hloch, Sergej
Prešov: TEAM Society
1847-9065
Podaci o skupu
5th International Scientific and Expert Conference TEAM 2013
ostalo
04.11.2013-06.11.2013
Prešov, Slovačka