The influence of heat treatment on fracture surface morphology of the CuAlNi shape memory alloy (CROSBI ID 237192)
Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Ivanić, Ivana ; Kožuh, Stjepan ; Kosel, Franc ; Kosec, Borut ; Anžel, Ivan ; Bizjak, Milan ; Gojić, Mirko
engleski
The influence of heat treatment on fracture surface morphology of the CuAlNi shape memory alloy
The influence of different heat treatment temperatures on microstructural and mechanical properties of CuAlNi shape memory alloy was determined. The samples were investigated in as- cast state and heat treated state at three different temperatures (700 °C, 740 °C and 780 °C). The heat treatment was conducted at above mentioned temperatures for a very short period of time (2 minutes) followed by water quenching (WQ). The microstructures in all samples were martensitic, and only in the sample that was heat treated at 780 °C after tensile testing small particles of some other phase were observed. According to tensile testing measurement, some samples show better results, but insufficient elasticity for proceeding to cold plastic deformation processes. Fractographic analysis shows the intergranular type of fracture in the area of columnar grains and the transgranular type of fracture in the centre of the sample where the equiaxial grains appear. The microhardnesses of the samples were in the range between 239 to 305 HV10.
shape memory alloys, CuAlNi, heat treatment, failure analysis, microstructure
Glavni autor: Ivana Ivanić, Stjepan Kožuh
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o izdanju
77
2017.
85-92
objavljeno
1350-6307
1873-1961
10.1016/j.engfailanal.2017.02.020