Influence of Drill Geometry and Chip Shape on the Quality of Drilled Holle in Composite Material (CROSBI ID 546423)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Koboević, Nikša ; Mišković, Ante
engleski
Influence of Drill Geometry and Chip Shape on the Quality of Drilled Holle in Composite Material
The drilling composite materials is a very common and important process used in the process of assembling of composite structures. In the process of composite material drilling the following errors happen: delamination, fraying, edge chipping, spalling, surface roughness and dimensional errors. The paper presents an experimental investigation of drilling of carbon and aramide reinforced composite material. In this paper it is explained how hole errors depend on drill geometry and the shape of the removed material chips.
Drilling; Composite materials; Hole quality
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
1301-1304.
2008.
objavljeno
Podaci o matičnoj publikaciji
Ekinović, Sabahudin ; Yalcin, Senay ; Vivancos, Calvet Joan
Istanbul: Faculty of Mechanical Engineering in Zenica, University of Zenica
978-9958-617-41-6
Podaci o skupu
Trends in the Development of Machinery and associated technology" TMT 2008
poster
26.08.2008-30.08.2008
Istanbul, Turska