Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Design of experiment's application in the optimization of milling process (CROSBI ID 156816)

Prilog u časopisu | prethodno priopćenje

Bajić, Dražen ; Jozić, Sonja ; Podrug, Srdjan Design of experiment's application in the optimization of milling process // Metalurgija, 49 (2010), 2; 123-126

Podaci o odgovornosti

Bajić, Dražen ; Jozić, Sonja ; Podrug, Srdjan

engleski

Design of experiment's application in the optimization of milling process

This paper examines the influence of cutting parameters on surface roughness of steel workpiece. The experiments have been carried out in accordance with a design of experiments (DOE). Equation for the surface roughness, as a function of cutting parameters, has been obtained by means of regression analysis. To obtain the minimal value of surface roughness, the equation optimizing was performed by using partial derivations and solving system of equations. The Taguchi method, with orthogonal arrays and signal to noise ratio, has been used to analyse impact of various cutting parameters on surface roughness and to find optimal levels of the cutting parameters. The comparison of results obtained by means of the response surface method and the Taguchi method was performed.

face milling; surface roughness; design of experiments; regression analysis; Taguchi method

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

49 (2)

2010.

123-126

objavljeno

0543-5846

Povezanost rada

Strojarstvo

Indeksiranost