crta
Hrvatska znanstvena Sekcija img
bibliografija
3 gif
 Naslovna
 O projektu
 FAQ
 Kontakt
4 gif
Pregledavanje radova
Jednostavno pretraživanje
Napredno pretraživanje
Skupni podaci
Upis novih radova
Upute
Ispravci prijavljenih radova
Ostale bibliografije
Slični projekti
 Bibliografske baze podataka

Pregled bibliografske jedinice broj: 43829

Zbornik radova

Autori: Barle, Jani; Jecić, Stjepan; Grubišić, Vatroslav
Naslov: On the reliability of residual stresses determined using the hole drilling method
( On the reliability of residual stresses determined using the hole drilling method )
Izvornik: Proceedings of 17. Danubia-Adria Symposium on Experimental Methods in Solid Mechanics / Holy, Stanislav (ur.). - Prag : Czech Society of Mechanics , 2000. 21-24.
Skup: 17. Danubia-Adria Symposium on Experimental Methods in Solid Mechanics
Mjesto i datum: Prag, Češka Republika, 11-14.10.2000.
Ključne riječi: residual stresses; drilling method; strain measurement
( residual stresses; drilling method; strain measurement )
Sažetak:
There are number of problems involved in calculating stresses from measured strain relief. The major calculation problem is high senstivity to strain measurement error as the depth from the surface H increases, and hole depth increment ÄH decreases. In order to obtain stress uncertainty values within preset limits the depth increment distribution used in calculations must be altered. The problem of optimizing the step distribution employing the Integral Method was considered. Schajer was the first to report that three or four depth insrements of variable size are the practical maximum. Vangi and Zuccarelo have calculated 4 or 8 depth increments respectively. In the foregoing papers, the analysis was restricted in total hole depth h/R<0.3 (R is the mean gage radius). The second theoretically acceptable calculation procedure, the Power Series Method, in attempting to obtain reliable results, describes that only linear stress fields can be calculated. In this paper, a procedure for obtaining error parameters from a series of experiments is described. Conceptually, this investigation is focused on extracting a maximum amount of useful information from the data on hand without the benefit of being able to repeat the experiment with more or better equipment. In addition, since the hole drilling measurements involve a variety of techniques and parameters, the approach of combining estimates of error obtained by using different models is not very reliable. Therefore, the present study concetrates on the overall error estimation for the particular measurement procedure.
Vrsta sudjelovanja: Predavanje
Vrsta prezentacije u zborniku: Sažetak
Vrsta recenzije: Međunarodna recenzija
Projekt / tema: 120011
Izvorni jezik: eng
Kategorija: Znanstveni
Znanstvena područja:
Strojarstvo



  Verzija za printanje   za tiskati


upomoc
foot_4