Design of experiment's application in the optimization of milling process (CROSBI ID 564393)
Prilog sa skupa u časopisu | sažetak izlaganja sa skupa | međunarodna recenzija
Podaci o odgovornosti
Bajić, Dražen ; Jozić, Sonja ; Podrug, Srdjan
engleski
Design of experiment's application in the optimization of milling process
This paper examines the influence of cutting parameters on surface roughness of steel workpiece. The experiments have been carried out in accordance with a design of experiments (DOE). Equation for the surface roughness, as a function of cutting parameters, has been obtained by means of regression analysis. To obtain the minimal value of surface roughness, the equation optimizing was performed by using partial derivations and solving system of equations. The Taguchi method, with orthogonal arrays and signal to noise ratio, has been used to analyse impact of various cutting parameters on surface roughness and to find optimal levels of the cutting parameters. The comparison of results obtained by means of the response surface method and the Taguchi method was performed.
face milling; surface roughness; design of experiments; regression analysis; Taguchi method
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
201-201.
2010.
nije evidentirano
objavljeno
Podaci o matičnoj publikaciji
Metalurgija
Mamuzić, Ilija
Zagreb: Hrvatsko metalurško društvo
0543-5846
Podaci o skupu
9th International Symposium of Croatian Metallurggical Cociety "Materials and Metallurgy"
poster
20.06.2010-24.06.2010
Šibenik, Hrvatska