crta
Hrvatska znanstvena Sekcija img
bibliografija
3 gif
 Naslovna
 O projektu
 FAQ
 Kontakt
4 gif
Pregledavanje radova
Jednostavno pretraživanje
Napredno pretraživanje
Skupni podaci
Upis novih radova
Upute
Ispravci prijavljenih radova
Ostale bibliografije
Slični projekti
 Bibliografske baze podataka

Pregled bibliografske jedinice broj: 641984

Zbornik radova

Autori: Plančak, Miroslav; Movrin, Dejan; Car, Zlatan; Durakbasa N.; Vilotić, Dragiša
Naslov: Orbital Forging of Cross Joint Component
Izvornik: International Conference on Innovative Technologies IN-TECH / Car, Zlatan ; Kudláček, Jan ; Szalay, Tibor (ur.). - Rijeka : Faculty of Engineering University of Rijeka , 2013. 265-268 (ISBN: 978-953-6326-88-4).
Skup: International Conference on Innovative Technologies IN-TECH
Mjesto i datum: Budimpešta, 10.09-13.09
Ključne riječi: orbital forging; cross joint; steel
Sažetak:
Forging technology enables manufacturing of parts with different shapes and from different materials. Due to high mechanical properties of forged components, this technology is mostly applied in the production of reliable and high loaded parts in automotive engine (e.g. crankshaft, connecting rod, turbine discs, gears etc). One specific forging method is rotary or orbital forging. This is a typical incremental process and it is distinctive in that the axis of upper die is inclined in relation to the vertical axis and performs swinging movement around vertical axis during compression. The main advantages of rotary forging, when compared with classical forging, are reduced load, increased workability, lower noise and vibration, longer die life. Rotary forging is, however, time consuming method and it is therefore successfully and economically applied mostly for fabrication of flat products with high diameter / height ratio in small batch production. Current paper elaborates manufacturing of steel cross joint by orbital forging technology. Numerical analysis and experimental investigation have been conducted with the aim to determine influence of inclination angle and billet geometry on forging load. Additionally, hardness analysis over the relevant cross sections has been performed.
Vrsta sudjelovanja: Pozvano
Vrsta prezentacije u zborniku: Cjeloviti rad (više od 1500 riječi)
Vrsta recenzije: Međunarodna recenzija
Projekt / tema: 069-1201787-1754
Izvorni jezik: ENG
Kategorija: Znanstveni
Znanstvena područja:
Metalurgija,Računarstvo,Strojarstvo
Upisao u CROSBI: Marko Kršulja (marko.krsulja@riteh.hr), 15. Ruj. 2013. u 00:05 sati



Verzija za printanje   za tiskati


upomoc
foot_4