crta
Hrvatska znanstvena Sekcija img
bibliografija
3 gif
 Naslovna
 O projektu
 FAQ
 Kontakt
4 gif
Pregledavanje radova
Jednostavno pretraživanje
Napredno pretraživanje
Skupni podaci
Upis novih radova
Upute
Ispravci prijavljenih radova
Ostale bibliografije
Slični projekti
 Bibliografske baze podataka

Pregled bibliografske jedinice broj: 477726

Zbornik radova

Autori: Liščić, Božidar; Singer, Saša; Beitz, Hartmut
Naslov: DEPENDENCE OF THE HEAT TRANSFER COEFFICIENT AT QUENCHING ON DIAMETER OF CYLINDRICAL WORKPIECES
Izvornik: Proceedings of the 18th IFHTSE CongressRio de Janeiro :
Skup: 18th Congress IFHTSE
Mjesto i datum: Rio de Janeiro, 26-30.07.2010.
Ključne riječi: Quenching; Heat transfer coefficient; Inverse heat conduction calculation
Sažetak:
For computer simulation of a quenching process, the fundamental prerequisite is to have the relevant heat transfer coefficient (HTC) calculated as function of work-piece's surface temperature and time respectively. In order to calculate the HTC experimental measurement of the temperature-time history (cooling curve) near the workpiece surface is necessary. In this investigation cylindrical probes of 20 mm, 50 mm and 80 mm diameter are used. The cooling curve was measured always at 1 mm below the surface of the probe. Special care has been taken to keep all other factors (design of the probes, temperature measurement, quenching conditions and calculation procedure), which can influence on the calculated HTC, constant, in order to assure that the only variable is the diameter of the probe. Supposing a radially symmetrical heat flow at half length of the probe, the HTC was calculated using 1-D inverse heat conduction method. The unexpected striking result of this investigation is the fact that for biggest probe diameter (80 mm) the calculated HTC as function of surface temperature does not show the film boiling phase. A plausible explanation of this effect is given, based on the critical heat flux density. The possibility to establish a simple fixed relation (a correction factor) between the HTC and the diameter of cylinders is discussed.
Vrsta sudjelovanja: Predavanje
Vrsta prezentacije u zborniku: Cjeloviti rad (više od 1500 riječi)
Vrsta recenzije: Međunarodna recenzija
Projekt / tema: 120-1201780-1779, 037-1193086-2771
Izvorni jezik: ENG
Kategorija: Znanstveni
Znanstvena područja:
Matematika,Strojarstvo
Upisao u CROSBI: tfiletin@fsb.hr (tfiletin@fsb.hr), 23. Srp. 2010. u 18:19 sati



Verzija za printanje   za tiskati


upomoc
foot_4