crta
Hrvatska znanstvena Sekcija img
bibliografija
3 gif
 Naslovna
 O projektu
 FAQ
 Kontakt
4 gif
Pregledavanje radova
Jednostavno pretraživanje
Napredno pretraživanje
Skupni podaci
Upis novih radova
Upute
Ispravci prijavljenih radova
Ostale bibliografije
Slični projekti
 Bibliografske baze podataka

Pregled bibliografske jedinice broj: 569163

Zbornik radova

Autori: Holik, Mario; Damjanović, Darko; Baškarić, Tomislav; Kozak, Dražan
Naslov: Integrity assessment of shipbuilding welded component by using of FAD diagram
Izvornik: Abstracts of 7th International PhD & DLA Symposium 7 / Fulop, Attila ; Habail, Peter (ur.). - Pecs : University of Pecs, Pollack Mihaly Faculty of Engineering and Information Tehnology , 2011. C55.
Skup: 7th PhD & DLA Symposium
Mjesto i datum: Pečuh, Mađarska, 24-25.10.2011.
Ključne riječi: crack; finite element method; SINTAP; R6 procedure; FAD diagram
Sažetak:
Thin-walled welded shipbuilding components are often the places of the initial cracks in exploitation. Therefore, it is recommended to determine the critical size of crack which causes plastic collapse of component. In this paper R6 procedure has been used to find critical depth of crack assuming that the crack is through whole section of component. Six various crack depths were analysed. Crack has been assumed perpendicular to the vector of principal stress σ1 at the location of its maximum. The stress which lead to yielding of remained ligament and corresponding stress intensity factor value were calculated by using of software based on finite element method. Fracture toughness for the material of the component has been estimated from the Charpy toughness. Finally, all six pairs of the loading path points (Kr, Lr) were lying in the safe area within FAD diagram, so the fifth order polynomial should be constructed in order to find critical point of intersection with the material curve in FAD diagram. Obtained results shown excellent fracture behaviour of the welded component, due to the fact that very deep cracks still will not cause the plastic collapse. However, this could be rapidly changed if the component is subjected to the fatigue.
Vrsta sudjelovanja: Predavanje
Vrsta prezentacije u zborniku: Sažetak
Vrsta recenzije: Međunarodna recenzija
Projekt / tema: 152-1201910-1909, 152-1201760-2202
Izvorni jezik: ENG
Kategorija: Znanstveni
Znanstvena područja:
Strojarstvo
URL Internet adrese: http://phdsymp.pmmik.pte.hu/en/
Upisao u CROSBI: ddamjan@sfsb.hr (ddamjan@sfsb.hr), 26. Sij. 2012. u 16:25 sati



Verzija za printanje   za tiskati


upomoc
foot_4