crta
Hrvatska znanstvena Sekcija img
bibliografija
3 gif
 Naslovna
 O projektu
 FAQ
 Kontakt
4 gif
Pregledavanje radova
Jednostavno pretraživanje
Napredno pretraživanje
Skupni podaci
Upis novih radova
Upute
Ispravci prijavljenih radova
Ostale bibliografije
Slični projekti
 Bibliografske baze podataka

Pregled bibliografske jedinice broj: 627184

Zbornik radova

Autori: Konjatić, Pejo; Kozak, Dražan; Samardžić, Ivan; Despotović, Božo
Naslov: Influence of technological flaw occurred during welding of header-nozzle joint using SAW welding process on the strength of welded joint
Izvornik: Design, Fabrication and Economy of Metal Structures / Jármai, Károly ; Farkas, József (ur.). - Miskolc, Hungary : Springer , 2013. 483-488 (ISBN: 978-3-642-36690-1).
Skup: Design, Fabrication and Economy of Metal Structures 2013
Mjesto i datum: Miškolc, Mađarska, 24-26.04.2013.
Ključne riječi: SAW welding; welded joint; flaw; inclusion; finite element method
Sažetak:
This paper deals with the influence of technological flaw, occurred during welding of header-nozzle joint using SAW welding process, on the strength of welded joint. Three models of welded joints geometry are modeled: model without flaw, model with assumption of flaw existence around whole length of welded joint in form of torus with 1 mm diameter (the most dangerous case) and model with largest measured flaw with 1 mm diameter and with length of 8 mm. Numerical analyses using finite element method have been conducted. From obtained results it can be concluded that technological flaw occurred during process of welding does not influence the static strength of welded joint because there is no increase in stress, which is in all three models lower than yield strength. Even in the worst case scenario, when flaw with same diameter as largest detected flaw (1 mm) would occur along whole length of weld, it is not registered stress increasing in the region of weld joint subjected to internal pressure of 102 bar. Since there is no significant stress concentrations around flaws in all three models i.e. stresses do not exceed yield strength of material, there are no plastic deformations.
Vrsta sudjelovanja: Predavanje
Vrsta prezentacije u zborniku: Cjeloviti rad (više od 1500 riječi)
Vrsta recenzije: Međunarodna recenzija
Projekt / tema: 152-1201910-1909, 152-1521473-1474, 152-1521473-1476
Izvorni jezik: ENG
Kategorija: Znanstveni
Znanstvena područja:
Strojarstvo
Upisao u CROSBI: Pejo Konjatic (pekon@sfsb.hr), 29. Tra. 2013. u 09:47 sati



Verzija za printanje   za tiskati


upomoc
foot_4