crta
Hrvatska znanstvena Sekcija img
bibliografija
3 gif
 Naslovna
 O projektu
 FAQ
 Kontakt
4 gif
Pregledavanje radova
Jednostavno pretraživanje
Napredno pretraživanje
Skupni podaci
Upis novih radova
Upute
Ispravci prijavljenih radova
Ostale bibliografije
Slični projekti
 Bibliografske baze podataka

Pregled bibliografske jedinice broj: 813672

Časopis

Autori: Par, Matej; Gamulin, Ozren; Marovic, Danijela; Skenderovic, Hrvoje; Klaric, Eva; Tarle, Zrinka
Naslov: Conversion and temperature rise of remineralizing composites reinforced with inert fillers
Izvornik: Journal of dentistry (0300-5712) 48 (2016); 26-33
Vrsta rada: članak
Ključne riječi: resin composite ; remineralizing composite ; conversion ; temperature ; raman spectroscopy ; amorphous calcium phosphate
Sažetak:
Objectives: Remineralizing experimental composites based on amorphous calcium phosphate (ACP) were investigated. The impact of curing time (20 and 40 s), curing depth (1, 2, 3 and 4 mm) and addition of inert fillers (barium glass and silica) on the conversion and temperature rise during curing were examined. Methods: Five ACP-composites and two control composites were prepared based on the light-curable EBPADMA-TEGDMA-HEMA resin. For temperature measurements, a commercial composite was used as an additional control. Conversion was assessed using FT-Raman spectroscopy by comparing the relative change of the band at 1640 cm-1 before and after polymerization. The temperature rise during curing was recorded in real-time using a T-type thermocouple. Results: At 1 mm depth, the ACP-composites attained significantly higher conversion (77.8–87.3%) than the control composites based on the same resin (60.5–66.3%). The addition of inert fillers resulted in approximately 5% lower conversion at clinically relevant depths (up to 2 mm) for the curing time of 40 s. Conversion decline through depths depended on the added inert fillers. Conversion values higher than 80% of the maximum conversion were observed for all of the ACP-composites at depths up to 3 mm, when cured for 40 s. Significantly higher total temperature rise for the ACP-composites (11.5–13.1 °C) was measured compared to the control composites (8.6–10.8 °C) and the commercial control (8.7 °C). Conclusions: The admixture of inert fillers represents a promising strategy for further development of ACP- composites, as it reduced the temperature rise while negligibly impairing the conversion. Clinical significance: High conversions of ACP- composites are favorable in terms of mechanical properties and biocompatibility. However, high conversions were accompanied with high temperature rise, which might present a pulpal hazard.
Projekt / tema: 08/31
Izvorni jezik: ENG
Current Contents: DA
Citation Index: DA
Kategorija: Znanstveni
Znanstvena područja:
Stomatologija
Tiskani medij: da
Broj citata:
Altmetric:
DOI: 10.1016/j.jdent.2016.03.008
Google Scholar: Conversion and temperature rise of remineralizing composites reinforced with inert fillers
Upisao u CROSBI: Matej Par (mpar@inet.hr), 3. Svi. 2016. u 15:12 sati



  Verzija za printanje   za tiskati


upomoc
foot_4